Author Topic: Problem with rotated parts (incorrectly positioned).  (Read 103 times)

dirk1980

  • Newbie
  • *
  • Posts: 9
    • View Profile
Problem with rotated parts (incorrectly positioned).
« on: May 21, 2019, 03:31:01 PM »
Hello.
I have a problem with rotated parts.
On a board (10*10cm) 95% of the components are in 90° and 5% in 0° on it.
All 0° components are incorrectly positioned 6-12MIL to the right.
The others are perfect.
Same components (1206 100nF   &  1206 10K)!

Now I have a new board where 99% are in 0° on it and I can see that the offset from left to right (20cm) increases from 6Mil to 20Mil.
Even a PLCC48 shifts from the left to the right side.

Does anyone have an idea what this could be?
Is it possible to move individual components around xMIL?

Regards, Dirk

Mike

  • Administrator
  • Hero Member
  • *****
  • Posts: 567
    • View Profile
Re: Problem with rotated parts (incorrectly positioned).
« Reply #1 on: May 21, 2019, 07:57:39 PM »
you can apply biases in rvplace. select the part then do edit component. you can select multiple parts and apply biases to all in one go