Problem with rotated parts (incorrectly positioned).

Started by dirk1980, May 21, 2019, 03:31:01 PM

Previous topic - Next topic


I have a problem with rotated parts.
On a board (10*10cm) 95% of the components are in 90° and 5% in 0° on it.
All 0° components are incorrectly positioned 6-12MIL to the right.
The others are perfect.
Same components (1206 100nF   &  1206 10K)!

Now I have a new board where 99% are in 0° on it and I can see that the offset from left to right (20cm) increases from 6Mil to 20Mil.
Even a PLCC48 shifts from the left to the right side.

Does anyone have an idea what this could be?
Is it possible to move individual components around xMIL?

Regards, Dirk


you can apply biases in rvplace. select the part then do edit component. you can select multiple parts and apply biases to all in one go