Setting up toolbank

[Zeus]

Hi all, I have an RV4s. I recently had to remove the tool bank and although I tried hard to replace it in exactly the same place now it will not quite release tool number 1 and I have to pull it off manually. It looks like it is just a fraction out. Is there a way of re-setting the machines location for the tool bank?

Thanks
David

[Gopher]

Yup go into the calibration/factory settings menu menu in RVplace.
There you can set each tool position and height and test it works. Just tick the tool position box shown in the screen shot in this thread. http://electricstuff.co.uk/forum/index.php?PHPSESSID=aac9499df3e2af7f791415d2d5cf00b9&topic=115.0

[Zeus]

Thanks Gopher.

That has worked a treat. (Scary screen though!) I have another question, will post in new thread.

David