Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - NIJI99

#1
For Sale/Wanted, Suppliers / Re: SOIC8 Plastic tubes
November 04, 2020, 04:25:40 PM
Gopher, many thanks, no preference just need to get hold of 4 tubes, as along with the 555's I use 3 other SOIC8 devices. Let me know when you have enough available and we can sort out details. cheers Nick
#2
For Sale/Wanted, Suppliers / SOIC8 Plastic tubes
November 02, 2020, 09:40:16 AM
Hi, I am looking for some SOIC8 plastic tubes for my RV4S vibration feeder. I use 555 timers, which have a pcb landing of 5.4mm to the centre of the feet, a body width of 3.9mm and a total height of 1.75mm. Happy to pay for them and postage by paypal. any offers ? thanks Nick
#3
For Sale/Wanted, Suppliers / Swap feeder
September 10, 2020, 09:28:33 AM
I have a 10 lane 8mm feeder last serviced on 20/04/20 and wondered if anybody would like to swap it for a 12mm feeder in good condition ? I am located in south Somerset. (Machine is an RV4S).
#4
RV Hardware / Re: General Help
September 10, 2020, 09:18:31 AM
Many thanks for your reply. I have moved on and am placing components both from the 10 lane feeders and my 3D printed jig for the job. One thng that I would like to clarify, is that I set up a new feeder as a matrix, entered the dimensional offsets x and y for the lanes. Set reference 1 and 2 then had to set biases for each component. I had a ssumed that the software would have calculated that. Is this correct to have to set all biases or did I set my lane offsets incorrectly ? Big learning curve !
#5
RV Hardware / Re: General Help
August 11, 2020, 10:09:15 AM
Gopher, many thanks for your reply. I have a copy of this manual and the original one. Things that are causing me problems are my job has components which are in strips of 12mm, 16mm. 24mm. I 3D printed a pocketed equi-pitched jig (16mm x 11mm - 4 x4 matrix) but can't seem to get the gist of setting this up as a passive feeder properly. What steps do I have to do to ensure that the head moves onto the next location of the same component for board 2 of my 2 x 2 matrix and so on. 
#6
RV Hardware / General Help
August 05, 2020, 04:56:08 PM
Hi, I recently purchased a very well used but well maintained RV4S. I had it demonstrated working perfectly. I just wondered if there are any RV4S guru's living close to me in South Somerset, who could go through a whole job set up. so I could take copius notes. 2 x 2 matrix of 60mm dia boards, about 30 components, 3D printed strip holders for the larger stuff, needing feeders set up properly. There's petrol money available if local. Thanks.