Last week, during placement, the vaccum on our RV4 randomly stopped working a couple of times, (sometimes just for 5 piscks or so) a bit off a cooloff or pc reset seemed to bring it back to life and the prblem has not manifested itself again since (touch wood). I'm thinking a sticky relay or dodgy connection somewhere, but not quite sure where to look. Last time it failed it was a control card swapout, but in that case it had stopped permenantly.
Any Ideas?
Thanks.......
If it helps the following day, it did something else: picked, took its image and then stopped, did nothing for about a minuite and then put up a "wait not busy" error box, followed by another I neglected to read properly about the arm. Had to manually park the arm and restart
control card. sounds like the comms on it is dying.
Yep, I'd second that.
And just how loudly should I be swearing and how tightly should my fingers be crossed? or is this a card phono just happens to sell on ebay?
oh, and where is this card so if it goes I can wave it at my lovely engineer?
Yep I can sort you out. I've emailed you separately.
Awesome, the longer I can squeeze life out of this wee bugger the better.