Hi
I've got a 10x8 feeder grey type where the index pins aren't moving in the Z direction, is this a fault anyone's seen before? They move back as forth in x but don't lift up to engage the tape (I've tried all 10 - none lift up)
Thanks in advance
Matt
Pins can get sticky-they clog with dust from paper tapes. A fatal mistake is to use oil to lubricate, as this forms a sticky mess with paper dust.
Assuming the solenoids are working, you probably nee to strip down and clean, with a non-oily cleaner
I have come across a couple of feeders where the solenoid driver on the control board had died. I don't think you can get that particular one any more, though it was massively over spec'd anyway.